SAFETY
1.6 Safety S igns
• Keep safety signs clean and legible at all times.
• Replace safety signs that are missing or
become illegib le.
• If original parts on which a safety sign was installed
are replaced, be sure repair part also bears current
safety sign.
• Safety signs are available from your Dealer
Parts D epartment.
• Safety signs are available from your M acDon Dealer.
Figure 1.14: Operator’s Manual Decal
1.6.1 Installing Safety Decals
1. Clean and
dry installation area.
2. Decide o
n exact location before you remove decal backing paper.
3. Remove s
maller portion of split backing paper.
4. Place si
gn in position and slowly peel back remaining paper, smoothing sign as it is applied.
5. Prick s
mall air pockets with a pin and smooth out.
214049
7
Revision A
To Next Page
