ASSEMBLY/SETUP IN STRUC TIONS
2.4.3 Installing the Linkage: M205
To install the linkage on an M205 windrower, follow
these steps :
1. Remove support (A) from the DWA linkage by
removing nut (B).
Figure 2.3
6: Linkage Support
2. Install two 3/4 in. x 4-1/2 in. long carriage head bolts (A)
in the windrower frame member lo cated b etween the
engine and caster wheels.
NOTE:
Move the h
oses located above the frame
member to
get the bolts in place.
Figure 2
.37: Frame Member under Windrower
214049 26 Revision A
To Next Page
Loading...
