MacDon M1 Series - Positioning Mirror Arms

215620 80 Revision A
3.11 Positioning Mirror Arms
The mirror/light support arms must be moved from the shipping position to the working position.

$
%

$
%
&

$
%
&

$
%
&
Figure 3.79: Mirror Arm in Shipping Position
1. Locate the mirror on the left cab-forward side of the
windrower cab.
2. Loosen retaining nut (A) and pivot nut (B) on support
arm (C).
3. Swivel support arm (C) cab-forward by 90°.
IMPORTANT:
Avoid pinching the wire harness when rotating the
mirror arms.

$
%
Figure 3.80: Mirror Arm in Working Position
4. Tighten retaining nut (A) to 39 Nm (29 lbf·ft).
5. Tighten pivot nut (B) to 26 Nm (19 lbf·ft).

$
%
&
'
(
Figure 3.81: Roof Harness and Mirror Harness Secured
6. To prevent pinching wires when adjusting the mirror
assemblies, ensure that roof harness (A) and power mirror
harness (B) (if installed) are secured as follows:
• Roof harness (A) to supports with cable ties (C)
• Mirror harness (B) (if installed) to roof harness (A) with
cable tie (D)
• Mirror harness (B) (if installed) to mirror arm tube with
cable tie (E)
7. Repeat Steps 1, page 80 to 6, page 80 to reposition the
right cab-forward mirror.
ASSEMBLING WINDROWER