215620 43 Revision A
Chapter 3: Assembling Windrower
Once the various shipping assemblies have been unloaded and separated, the windrower can be assembled into field
position.
3.1 Lifting Windrower onto Assembly Stand
The windrower must be assembled on a MacDon Export Assembly Lift Stand.
DANGER
To prevent injury to bystanders and to avoid striking them with machinery, do NOT allow people to stand in the
unloading area.
DANGER
The equipment used for loading or unloading a header must meet or exceed the requirements specified in this
document. Using inadequate equipment may result in chain breakage, vehicle tipping, machine damage or bodily harm
to operators or bystanders.
1. Before lifting the windrower onto an assembly stand, ensure lifting device meets or exceeds the specified
requirements and refer to the following topics:
• If lifting with a forklift, refer to 2.2.2 Moving to Assembly Area – Forklift Method, page 26
• If lifting with a crane, refer to 2.2.1 Moving to Assembly Area – Crane Method, page 24
To Next Page
Loading...
