Command Response
AT+GPSSTART="STOP" OK
Note: stop GPS engine.
AT+GPSSTART="OFF" OK
Note: turn off the GPS.
AT+GPSSTART="IDLE" OK
Note: turn on the GPS and leave it to idle.
AT+GPSSTART? +GPSSTART: "IDLE","WARM","AGPSON"
AT+GPSSTART=? +GPSSTART: ("OFF","STOP","START","IDLE",
"HIBERNATE","DEEP"),("HOT","WARM","COLD",
"FACTCOLD"),("AGPSON","AGPSOFF")
Note:
– If any parameter of the command is omitted, the value of those will remain unchanged.
– Sate of GPS can be set to another directly, e.g. when the GPS is originally in "OFF" state, the command
AT+GPSSTART="IDLE" will first start the GPS and then put it to IDLE state.
– All parameters are saved and will be set on next power up.
AT+GPSSTOP
To stop the GPS function (put it to initialized mode).
Syntax: AT+GPSSTOP
Response: OK
Example:
Command Response
AT+GPSSTOP OK
Note: stops GPS, equivalent to AT+GPSSTART="STOP"
AT+GPSOFF
To switch off the GPS function.
Syntax: AT+GPSOFF
Response: OK
Example:
Command Response
AT+GPSOFF OK
Note: releases GPS, equivalent to AT+GPSSTART="OFF"
AT+AGPS
To set the AGPS function and check AGPS download details.
110 Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
To Next Page
Loading...
