Maestro M1002G - Page 111

Syntax: AT+AGPS=<agps>
Response: +AGPS: <agps>[,<ee-period>]
Defined Values:
<agps> enable AGPS feature:
1 enable AGPS
0 disable AGPS (default)
<ee-period> will display valid Timer is running (1) or stop (0).period of EE data, if successfully downloaded. Format
is "YY/MM/DD,hh:mm:ss", "YY/MM/DD,hh:mm:ss" time from start to end.
Example:
Command
Response
AT+AGPS=1
OK
Note: enable, equivalent to AT+GPSSTART=„"AGPSON"
AT+AGPS=0
OK
Note: disable, equivalent to AT+GPSSTART=„"AGPSOFF"
AT+AGPS?
+AGPS: 1,"13/05/28,06:00:00","13/06/28,06:00:00"
OK
AT+AGPS=?
+AGPS: (0-1)
OK
AT+NMEA
To set the output of NMEA messages to desired com port
Syntax: AT+NMEA=<port>
Response: +NMEA: <port>
Defined Values:
<port> output port for NMEA data stream:
2 enable NMEA output on USB COM port.
1 enable NMEA output on Serial port.
0 disable output (default).
Example:
Command Response
AT+NMEA=1 OK
AT+NMEA? +NMEA: 1
OK
AT+NMEA=? +NMEA: (0-2)
OK
Note:
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
111