Fuel Limiter
Inspection / Adjust
A5.05. 05.04.01.00
3750
M20/M282/M332C/M452/M453C/M551/M552C
en / 30.05.2000 IB021621 2/2
05
Ĺ
3.2 Check whether the piston follows the charge air pressure change continuously and without
hesitation. Overhaul the fuel limiter if piston operation is not satisfactory.
Piston travel = 26 mm
3.3 If the exhaust gas becomes black turn adjusting screw (2) 1 to 1.5 turns clockwise to
increase the spring load.
3.4 Speed the engine up again and check the exhaust gas.
3.5 If the regulating speed is too slow turn the adjusting screw (2) counterclockwise until the
regulating speed is as desired without smoke in the exhaust.
4. Check the maximum fuel limiting screw (3) for correct position.
5. Lock the screws.
To Next Page
Loading...
General