Parametrization of emergency drive
129
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
“Display configuration” - set the operator's stand in the display
Press button:
The following view is displayed:
Free IDs that are not yet used in the system
configuration are displayed under “Choose stand
ID”.
An ID can be selected via “SELECT”.
In principle, it is irrelevant which of the free IDs is
selected; when the system configuration is
completed no more free IDs should be present!
If the display already has a parametrized
operator's stand, it can be removed by clicking on
the button “Unregister stand”.
Alternatively, cancel the procedure with
“CANCEL”.
To Next Page
Loading...
Need help?
General