Control and operation
84
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
Electronic control units error memory (output)
(This page is only available in English)
Here the detailed output of the control unit error memory is displayed and is intended for the MAN
(authorized) service engineer.
The error page (DM1) has up to three tabs:
S ECU (=EDC)
S ECU slave (only with V-engines)
S MCS
The following values can be queried:
S SPN (Suspect Paramater Number)
S STATUS
S PRIO
S OCC (Occurance - frequency number)
Explanation of icons
Engine fault
Emissions error
Buttons in the footer line (depending
on equipment):
Up
Down
Switch to DM4 page
To Next Page
Loading...
Need help?
General