Control and operation
88
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
Seamless command transfer to another operator's stand is possible (with retention of the gearbox position
and engine speed).
if emergency drive mode has been activated at an operator’s stand and speed and gearbox operating
direction have been selected there, command can be taken over from another operator’s stand.
To activate another operator's stand, the same steps must be implemented as when one calls up the
emergency drive function “new”. See “Activation of emergency drive control”.
If the newly selected operator’s stand has activated, the drive function in the “previous” display is
automatically deactivated. The page will be closed.
General information:
S In case of a malfunction of the emergency drive function in the display, the symbol “Emergency drive” is
colored red in the display header line. The page cannot be opened.
More precise troubleshooting is possible via the “Emergency drive settings” page.
→ See parametrization, emergency drive function page 127
S If emergency drive is active, other pages can no longer be retrieved in the display. (Including the alarm
page!). The emergency drive function must be deactivated to be able to change pages.
S If the 7" display is not supplied from the MAN E-box (i.e. is switched on) but the other engine electronics
are switched off, then the emergency drive function is not available. The symbol in the display header
line and the sub-menu are hidden.
To Next Page
Loading...
Need help?
General