Control and operation
89
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
Start/stop
For parametrization of the start/stop function, see page 122
The start/stop function in the display allows the engine to be started and stopped from the display.
This function is only available for non-classified applications.
The page for the start/stop function can be retrieved either by pressing on the symbol for the start/stop
function in the display header line or via the main menu.
The start button is unlock by “swiping” the lock
button to the right.
Repeated „swipe“ locks the button
S Start engine with button “HOLD TO START
ENGINE” (see engine rpm)
S Stop engine with button “STOP ENGINE”
(Stop button always available)
General information:
S In the case of a malfunction of the start/stop function in the display, the symbol “Start/stop” is colored
red in the display header line. The page cannot be opened.
More precise troubleshooting is possible via the “Start/stop settings” page. → See parametrization of
the start/stop function
S If the display with the start/stop function is not supplied from the MAN E-box (i.e. is switched on) but the
other engine electronics are switched off, then the start/stop function is not available. The symbol in the
display header line and the sub-menu are hidden.
To Next Page
Loading...
Need help?
General