POWER TRAIN TMS700E SERVICE MANUAL
7-28 Published 01-29-2015, Control # 512-01
6. Remove the hardware securing the top center hood
panel to the front and rear cowls and remove the panel
with doors from the crane.
7. Remove the hardware securing the left and right lower
side panels to the front cowl.
8. Remove the hardware securing the front grill panel to
the front cowl and remove the grill.
9. Remove the hardware securing the front cowl and
remove the front cowl.
10. Disconnect the CAC hoses from the air cooler assembly.
11. Disconnect the hoses from the top and bottom of the
radiator assembly.
12. Remove the bolts, washers, and lockwashers attaching
the fan guard to the shroud. Remove the fan guard.
NOTE: The radiator assembly weighs approximately 116
kg (256 lb).
13. Attach an adequate lifting device to the radiator/air
cooler assembly.
14. Remove the nuts, hardened washers and mounts
securing the radiator/air cooler assembly to the
mounting brackets and remove the assembly from the
carrier.
Installation
1. Position the radiator/air cooler assembly in the carrier
using a lifting device and secure to the mounting
brackets using the mounts, hardened washers, and
nuts.
2. Position the fan guard on the shroud and secure with
bolts, washers, and lockwashers.
3. Connect the air cooler tubes to the air cooler using the
bellows and clamps. Tighten the clamps to 4 to 5 Nm (35
to 45 in-lb).
4. Connect the hoses to the top and bottom of the radiator.
5. Ensure the drain cock is closed
6. Position the front cowl on the frame and secure with the
attaching hardware
7. Position the front grill panel on the front cowl and secure
with the attaching hardware.
8. Attach the left and right side lower panels to the front
cowl with the attaching hardware.
9. Position the top center panel, with doors attached, on
the front and rear cowl and secure with the attaching
hardware.
10. Install the coolant recovery tank. Connect the hoses to
the tank.
11. Service the engine coolant system as necessary, Engine
Antifreeze/Coolant Fill Procedure (after a complete
draining of the system), page 7-22. Start the engine,
operate all systems and check for leaks.
Reference Only
To Next Page
Loading...
Need help?
General
