Manitowoc Published 08-06-19, Control # 237-09_v2 4-49
MLC165-1 OPERATOR MANUAL SETUP AND INSTALLATION
Connect Boom Butt Hydraulic Hoses
Proceed as follows, if equipped with a drum in the boom butt.
See Figure 4-41
.
1. Stop the engine.
2. Disconnect the hydraulic hoses (2) from the storage
brackets (1, Views A and B).
3. Disconnect the dust caps from the ends of the hydraulic
hoses.
4. Thoroughly clean all hydraulic couplers.
5. Connect the hydraulic hoses (2) from the boom butt to
the hydraulic hoses (3) on the crane.
The hoses at location (A, View C) can be connected only
one way.
The hoses between locations (B and C, View C) must
not cross. They must be connected in the same order at
point C as they are at point B.
Complete Boom and Jib Assembly
Finish assembling the boom and jib as needed. See:
• Boom #74A Assembly on page 4-91
• Jib #134 Assembly on page 4-107
To Next Page
Loading...
Need help?
General
