Manitowoc MLC165-1 User Manual

Manitowoc Published 08-06-19, Control # 237-09_v2 4-11
MLC165-1 OPERATOR MANUAL SETUP AND INSTALLATION
4
CRANE ASSEMBLY
Remove Crane from Trailer
See Figure 4-8.
1. Attach owner furnished lifting slings (3) from the assist
crane to shackles (4) at the lifting holes (5) in the rotating
bed of the MLC165-1.
Refer to the Lifting Assembly 81023872 at the end of this
section for sling and pick point specifications and for the
total weight to be lifted.
It is crane owner’s responsibility to properly size the
assist crane, the lifting slings, and the shackles for
the weight to be lifted.
2. Remove all chains and straps used to secure the
carbody (7) to the trailer (2).
3. Lift the MLC165-1 off the trailer and place it on hard-
wood blocking (6) under the four corners of the carbody
(7).
• The blocking must be sized and positioned as
shown so the carbody is 25-28 in (635-711 mm)
above the ground.
• The blocking at each corner must be capable of
supporting at least 52,000 lb (23 587 kg).
4. Disconnect the lifting slings and shackles.
DANGER
Tipping Hazard!
Swing is prohibited while the crane is on blocking.
Do not swing the MLC165-1 upperworks until after the first
crawler is installed and resting on the ground.

Manitowoc MLC165-1 Specifications

General

Brand	Manitowoc
Model	MLC165-1
Category	Construction Equipment
Language	English