Manitowoc MLC165-1 User Manual

Manitowoc Published 08-06-19, Control # 237-09_v2 4-75
MLC165-1 OPERATOR MANUAL SETUP AND INSTALLATION
4
Remove Crawlers – Preliminary Steps
See Figure 4-56 for the following procedure.
1. At both crawlers, remove the wire-lock pins (6C, View C)
and unhook the crawler step (6a) from the bar (6b).
2. Reinstall the wire-lock pins (6c) in the crawler steps and
secure the steps to a trailer.
3. At the drive end of both crawlers:
a. Remove the guard (1, View A) from the crawler.
b. Uncouple the dust caps (4, View D) and thoroughly
clean them.
c. Stop the engine.
d. Disconnect the hydraulic hoses (2, View D) from the
carbody at the hydraulic tubes (5) on the crawler.
e. Thoroughly clean all fittings.
f. Apply a light coat of silicone lubricant to the threads
of all dust caps, couplers, and connectors to help in
preventing the threads from seizing.
g. Connect the dust caps to the couplers on the
crawler and to the hoses on the carbody.
h. Store the hoses (2, View B) under the brackets (3)
on the carbody.
i. Reinstall the guard (1, View A).

Manitowoc MLC165-1 Specifications

General

Brand	Manitowoc
Model	MLC165-1
Category	Construction Equipment
Language	English