Manitowoc MLC165-1 - Connect Boom Straps

Manitowoc Published 08-06-19, Control # 237-09_v2 4-97
MLC165-1 OPERATOR MANUAL SETUP AND INSTALLATION
4
Connect Boom Straps
See Figure 4-70 for the following procedure.
1. If desired, install the optional boom ladders to access
the straps (see Boom Ladders on page 4-85
).
If equipped with optional catwalks, workers can also
access the straps from the top of the inserts. Take every
precaution to prevent falling off the inserts.
2. Connect the boom straps at the top end of each insert,
as follows:
a. Move storage pins (1) from the stored position (View
A) to the working position (View B).
b. Remove pins (3, View A) and the collars from the
ends of boom straps (4).
c. Rotate links (5, View A) to the working position
(View B).
d. Install pins (4, View B) and the collars so the pin
heads are on the INBOARD SIDE.