©2019 MANITOWOC
Published 08-06-19, Control # 237-09_v3
OPERATOR MANUAL
This manual has been prepared for and is considered part of -
MLC165-1
Crane Model Number
XXXXXRef
Crane Serial Number
This Manual is divided into the following sections:
SECTION 1 INTRODUCTION
SECTION 2 SAFETY INFORMATION
SECTION 3 OPERATING CONTROLS AND PROCEDURES
SECTION 4 SET-UP AND INSTALLATION
SECTION 5 LUBRICATION
SECTION 6 MAINTENANCE CHECKLIST
NOTICE
The serial number of the crane and applicable attachments (for example, a luffing jib) is the only method
a Manitowoc dealer or the Manitowoc Crane Care Lattice Team has of providing the correct parts and
service information.
The serial number is located on a crane identification plate attached to the operator cab and each
attachment. Refer to the Nameplate and Decal Assembly drawing in Section 2 of this manual for the
exact location of the crane identification plate.
Always furnish serial number of crane and its attachments when ordering parts or discussing
service problems with a Manitowoc dealer or the Manitowoc Crane Care Lattice Team.
To prevent death or serious injury:
• Avoid unsafe operation and maintenance.
Crane and attachments shall be operated and maintained by trained and
experienced personnel. Manitowoc is not responsible for qualifying these
personnel.
• Do not operate or work on crane or attachments without first reading and
understanding instructions contained in the manuals supplied with crane
and applicable attachments.
• Store crane manuals in the operator cab.
If crane manuals are missing from the cab, contact a Manitowoc dealer for
new ones.
WARNING
To Next Page
Loading...
