Manitowoc MLC165-1 - Page 70

OPERATING CONTROLS AND PROCEDURES MLC165-1 OPERATOR MANUAL
3-20
Published 08-06-19, Control # 237-09_v1
5
Self-Assembly Controls
(operable only in setup mode)
To turn on setup mode, see
instructions in Section 4 of
MLC165-1 Operator Manual.
The swing/travel alarm will
sound when these switches are
operated.
Table 3-6. Overhead Console
Item Description
A
Self-assembly cylinder switch: used to retract and extend the self-
assembly cylinder. The cylinder can also be operated using the
Drum 3/4 control handle as instructed on page 3-17
.
• Press to RETRACT the self-assembly cylinder.
• Press to EXTEND the self-assembly cylinder.
B
Mast-assist arms switch: used to raise and lower the mast assist
arms. Refer to Section 4 of the MLC165-1 Operator Manual for
detailed mast raising and lowering instructions.
• Press to RAISE the mast assist arms (extend cylinder).
• Press to LOWER the mast assist arms (retract cylinders).
C
Boom hinge pins switch: used to engage and disengage the boom
hinge pins. Refer to Section 4 of the MLC165-1 Operator Manual for
detailed mast raising and lowering instructions.
• Press to DISENGAGE the boom hinge pins.
• Press to ENGAGE the boom hinge pins.
M100290A
A
BC