Marvell Integrated Controller 88F6281

To Next Page

To Previous Page

88F6281

Hardware Specifications

Page 22 Document Classification: Proprietary Information December 2, 2008, Preliminary

PEX_AVDD I Power PCI Express PHY quiet power supply 1.8V

NOTE: See the 88F6180, 88F6190, 88F6192, and 88F6281 Design

Guide for power supply filtering recommendations.

SATA0_AVDD

SATA1_AVDD

I Power SATA II port0/1 quiet 3.3V power supply

NOTE: See 88F6180, 88F6190, 88F6192, and 88F6281 Design Guide

for power supply filtering recommendation.

USB_AVDD I Power USB 2.0 PHY quiet 3.3V power supply

NOTE: See the 88F6180, 88F6190, 88F6192, and 88F6281 Design

Guide for power supply filtering recommendation.

RTC_AVDD I Power 1.5V (via battery) or 1.8V (via the board) RTC interface voltage

RTC_AVSS I GND RTC ground

Table 3: Power Pin Assignments (Continued)

Pin Name I/O Pin

Type

Description

Main Page

Default Chapter1
- Hardware Specifications1
Product Overview3
Features4
- Table of Contents8
Preface15
- About this Document15
- Related Documentation15
- Document Conventions16
Pin and Signal Descriptions17
- Pin Logic18
- Figure 1: 88F6281 Pin Logic Diagram18
- Pin Descriptions19
Pin and Signal Descriptions19
- Table 1: Pin Functions and Assignments Table Key19
- Table 2: Interface Pin Prefix Codes19
- Table 3: Power Pin Assignments21
- Table 4: Miscellaneous Pin Assignments23
- Table 5: DDR SDRAM Interface Pin Assignments24
- Table 6: PCI Express Interface Pin Assignments26
- Table 7: SATA Port Interface Pin Assignment27
- Table 8: Gigabit Ethernet Port0/1 Interface Pin Assignments28
- Table 9: Serial Management Interface (SMI) Pin Assignments32
- Table 10: USB 2.0 Interface Pin Assignments33
- Table 11: JTAG Pin Assignment34
- Table 12: RTC Interface Pin Assignments35
- Table 13: NAND Flash Interface Pin Assignment36
- Table 14: MPP Interface Pin Assignment37
- Table 15: Two-Wire Serial Interface (TWSI) Interface Pin Assignment38
- Table 16: UART Port 0/1 Interface Pin Assignment39
- Table 17: Audio (S/PDIF / I 2 S) Interface Signal Assignment40
- Table 18: Serial Peripheral Interface (SPI) Interface Signal Assignment41
- Table 19: Secure Digital Input/Output (SDIO) Interface Signal Assignment42
- Table 20: Time Division Multiplexing (TDM) Interface Signal Assignment43
- Table 21: Transport Stream (TS) Interface Signal Assignment45
- Table 22: Precise Timing Protocol (PTP) Interface Signal Assignment47
- Internal Pull-Up and Pull-Down Pins48
- Table 23: Internal Pull-Up and Pull-Down Pins48
2 Unused Interface Strapping49
Unused Interface Strapping49
- Table 24: Unused Interface Strapping49
88F6281 Pin Map and Pin List50
Pin Multiplexing51
- Multi-Purpose Pins Functional Summary51
4 Pin Multiplexing52
3 88F6281 Pin Map and Pin List52
- Table 25: MPP Functionality52
- Table 26: MPP Function Summary53
- Gigabit Ethernet (Gbe) Pins Multiplexing on MPP57
- Table 27: Ethernet Ports Pins Multiplexing57
- TSMP (TS Multiplexing Pins) on MPP59
- Table 28: TS Port Pin Multiplexing59
5 Clocking60
Clocking60
- Table 29: 88F6281Clocks60
- Table 30: Supported Clock Combinations61
- Spread Spectrum Clock Generator (SSCG)62
6 System Power Up/Down and Reset Settings63
5 Clocking63
System Power Up/Down and Reset Settings63
- Power-Up/Down Sequence Requirements63
- Table 31: I/O and Core Voltages63
- Hardware Reset64
- Figure 2: Power-Up Sequence Example64
- PCI Express Reset66
- Sheeva ™ CPU TAP Controller Reset66
- Pins Sample Configuration66
- Table 32: Reset Configuration67
- Serial ROM Initialization70
- Figure 3: Serial ROM Data Structure70
- Boot Sequence71
- Figure 4: Serial ROM Read Example71
7 JTAG Interface73
JTAG Interface73
- TAP Controller73
- Instruction Register73
- Table 33: Supported JTAG Instructions73
- Bypass Register74
- JTAG Scan Chain74
- ID Register74
- Table 34: IDCODE Register Map74
8 Electrical Specifications (Preliminary)75
Electrical Specifications (Preliminary)75
- Absolute Maximum Ratings75
- Table 35: Absolute Maximum Ratings75
- Recommended Operating Conditions77
- Table 36: Recommended Operating Conditions77
- Thermal Power Dissipation79
- Table 37: Thermal Power Dissipation79
- Current Consumption80
- Table 38: Current Consumption80
- DC Electrical Specifications81
- Table 39: General 3.3V Interface (CMOS) DC Electrical Specifications81
- Table 40: RGMII 1.8V Interface (CMOS) DC Electrical Specifications82
- Table 41: SDRAM DDR2 Interface DC Electrical Specifications83
- Table 42: TWSI Interface 3.3V DC Electrical Specifications84
- Table 43: SPI Interface 3.3V DC Electrical Specifications84
- Table 44: TDM Interface 3.3V DC Electrical Specifications85
- AC Electrical Specifications86
- Table 45: Reference Clock AC Timing Specifications86
- Table 46: SDRAM DDR2 Interface AC Timing Table88
- Table 47: SDRAM DDR2 Interface Address Timing Table89
- Table 48: SDRAM DDR2 Clock Specifications90
- Figure 5: SDRAM DDR2 Interface Test Circuit91
- Figure 6: SDRAM DDR2 Interface Write AC Timing Diagram91
- Figure 7: SDRAM DDR2 Interface Address and Control AC Timing Diagram92
- Figure 8: SDRAM DDR2 Interface Read AC Timing Diagram92
- Table 49: RGMII 10/100/1000 AC Timing Table at 1.8V93
- Table 50: RGMII 10/100 AC Timing Table at 3.3V93
- Figure 9: RGMII Test Circuit94
- Figure 10: RGMII AC Timing Diagram94
- Table 51: GMII AC Timing Table95
- Figure 11: GMII Test Circuit95
- Figure 12: GMII Output AC Timing Diagram96
- Figure 13: GMII Input AC Timing Diagram96
- Table 52: MII/MMII MAC Mode AC Timing Table97
- Figure 14: MII/MMII MAC Mode Test Circuit97
- Figure 15: MII/MMII MAC Mode Output Delay AC Timing Diagram97
- Figure 16: MII/MMII MAC Mode Input AC Timing Diagram98
- Table 53: SMI Master Mode AC Timing Table99
- Figure 17: MDIO Master Mode Test Circuit99
- Figure 18: MDC Master Mode Test Circuit100
- Figure 19: SMI Master Mode Output AC Timing Diagram100
- Figure 20: SMI Master Mode Input AC Timing Diagram100
- Table 54: JTAG Interface AC Timing Table101
- Figure 21: JTAG Interface Test Circuit101
- Figure 22: JTAG Interface Output Delay AC Timing Diagram102
- Figure 23: JTAG Interface Input AC Timing Diagram102
- Table 55: TWSI Master AC Timing Table103
- Table 56: TWSI Slave AC Timing Table103
- Figure 24: TWSI Test Circuit104
- Figure 25: TWSI Output Delay AC Timing Diagram104
- Figure 26: TWSI Input AC Timing Diagram104
- Table 57: S/PDIF AC Timing Table105
- Figure 27: S/PDIF Test Circuit106
- Table 58: Inter-IC Sound (I2S) AC Timing Table107
- Figure 28: Inter-IC Sound (I2S) Test Circuit107
- Figure 29: Inter-IC Sound (I2S) Output Delay AC Timing Diagram108
- Figure 30: Inter-IC Sound (I2S) Input AC Timing Diagram108
- Table 59: TDM Interface AC Timing Table109
- Figure 31: TDM Interface Test Circuit109
- Figure 32: TDM Interface Output Delay AC Timing Diagram110
- Figure 33: TDM Interface Input Delay AC Timing Diagram110
- Table 60: SPI (Master Mode) AC Timing Table111
- Figure 34: SPI (Master Mode) Test Circuit111
- Figure 35: SPI (Master Mode) Output AC Timing Diagram112
- Figure 36: SPI (Master Mode) Input AC Timing Diagram112
- Table 61: SDIO Host in High Speed Mode AC Timing Table113
- Figure 37: Secure Digital Input/Output (SDIO) Test Circuit113
- Figure 38: SDIO Host in High Speed Mode Output AC Timing Diagram114
- Figure 39: SDIO Host in High Speed Mode Input AC Timing Diagram114
- Table 62: Transport Stream Output Interface AC Timing Table115
- Table 63: Transport Stream Input Interface AC Timing Table115
- Figure 40: Transport Stream Interface Test Circuit116
- Figure 41: Transport Stream Output Interface AC Timing Diagram116
- Figure 42: Transport Stream Input Interface AC Timing Diagram117
- Differential Interface Electrical Characteristics118
- Table 64: PCI Express Interface Differential Reference Clock Characteristics118
- Table 65: PCI Express Interface Spread Spectrum Requirements119
- Table 66: PCI Express Interface Driver and Receiver Characteristics120
- Figure 43: PCI Express Interface Test Circuit121
- Table 67: SATA-I Interface Gen1I Mode Driver and Receiver Characteristics123
- Table 68: SATA-II Interface Gen2I Mode Driver and Receiver Characteristics124
- Table 69: USB Low Speed Driver and Receiver Characteristics125
- Table 70: USB Full Speed Driver and Receiver Characteristics126
- Table 71: USB High Speed Driver and Receiver Characteristics127
- Figure 44: Low/Full Speed Data Signal Rise and Fall Time127
- Figure 45: High Speed TX Eye Diagram Pattern Template128
- Figure 46: High Speed RX Eye Diagram Pattern Template128
9 Thermal Data (Preliminary)129
Thermal Data (Preliminary)129
- Table 72: Thermal Data for the 88F6281 in the BGA 19 X 19 MM Package (Preliminary)129
10 Package130
9 Thermal Data (Preliminary)130
Package130
- Figure 47: HSBGA 288-Pin Package and Dimensions130
- Table 73: HSBGA 288-Pin Package Dimensions131
11 Part Order Numbering/Package Marking132
Part Order Numbering/Package Marking132
- Part Order Numbering132
- Table 74: 88F6281 Part Order Options132
- Figure 48: Sample Part Number132
- Package Marking133
- Figure 49: Commercial Package Marking and Pin 1 Location133
Revision History134
- Table 75: Revision History134
A Revision History134

Marvell Integrated Controller 88F6281 - Page 22

Table of Contents

Related product manuals