ENGLISH
OPERATOR'S MANUAL
48
Cod. EKE0002OM
You can adjust bale size using threaded rod (4) for bale size setting illustrated in
Figure 4. You can make short bales in upward position and long bales in downward position.
Bales can be formed in 300mm -1350mm sizes.
Figure 4
5.2. Front Flywheel Tripod Clutch Lining Adjustment
Friction lining compressed between groove motion pivot (1) and tripod cast component
(2) constitute skid-belt clutch mechanism. Shear bushings (3) run with flywheel lock shear nut
(M10x65) (4) to protect main drive components of the bale machine against pulses arising
from overload, and transmits the motion to flywheel (5). Flywheel rotation rod (6) transmits
torque and motion to the transmission (7). (Figure 1)
Figure 1
To Next Page
Loading...
