ENGLISH
OPERATOR'S MANUAL
62
Cod. EKE0002OM
5.8. Adjustments to Perform When Shear Bolt Break
There are 3 each shear bolts on PITAGORA INLINE Machine.
Flywheel Unit
There is 1 each M10X65mm shear bolt (1) on the flywheel unit. If it breaks, turn the
flywheel first, and remove broken bolt pieces from bushings. After cleaning is complete, align
the shear bolt bushing hole on flywheel rotation arm with the hole on flywheel, and insert
M10X65mm shear bolt through both holes.( Figure 1)
Figure 1
Transmission Unit
There is 1 each M10X45mm hayfork shear bolt (2) on the transmission unit. If it
breaks, turn the chain gear located on the transmission first, and remove broken bolt pieces
from shear bolt bushings. Then, align the shear bolt bushing hole on transmission shear bolt
flange and the shear bolt bushing hole on transmission chain gear, and insert M12X45mm
hayfork shear bolt through both holes. (Figure 2)
To Next Page
Loading...
