10 Matrox Display Wall – User Guide
Before you begin
To avoid personal injury and to prevent damage to your system or Matrox hardware, read the
following guidelines before installing your Matrox hardware.
Using a validated platform
For detailed information on how to install your Matrox Mura card in a validated systems,
see the Matrox System Builder’s Guide (www.matrox.com/mura/support
).
For information on validated systems, motherboards, and chassis models, contact your
Matrox representative or see the Matrox web site (www.matrox.com/graphics
).
Preventing damage to your hardware
When installing your hardware
Always turn off your system, unplug it, then wait for it to cool before touching any of the
internal parts of your system or installing your Matrox product.
While your system is turned off but still plugged in, some electrical current is supplied
to the motherboard. This current may prevent newly installed hardware from working
properly.
Static electricity can severely damage electronic parts. Before touching any electronic
parts, drain static electricity from your body (for example, by touching the metal frame
of your system).
When handling a card, carefully hold it by its edges and avoid touching its circuitry.
Always try to insert or remove your card as straight as possible.
When connecting your hardware
Whenever you change your connection setup, make sure you’re using the correct
connectors and that all connectors are properly fastened.
Don’t change connections while your system is turned on. Before changing connections,
make sure your system is shut down and turned off.
Whenever you restart your system, make sure your monitors are already turned on.
Otherwise, the software may not be able to properly detect your monitors.
When connecting devices, make sure the connectors are properly fastened.
To Next Page
Loading...
