Matrox C Series - Setting up a Display Wall; Setup Overview; Mura IPX Series Display Card; Mura IPX Series Capture Cards

Matrox Display Wall – User Guide 17
Setting up a display wall
The following outlines the steps for installing, connecting, and setting up your Matrox card.
Setup overview
Mura IPX Series display card
1 Install your Matrox cards – see page 24.
2 Connect your cards – see page 32.
3 Update the software on your cards – see page 54.
4 Configure your display wall. You can use the following:
 Matrox Network API – see page 55.
 MuraControl for Windows – see page 57.
Mura IPX Series capture cards
1 Install your Matrox cards – see page 24.
2 Connect your cards – see page 34.
3 Install your Matrox software – see page 53.
4 Configure your display wall. You can use the following:
 Matrox Network API – see page 55.
 Matrox PowerDesk – see page 55.
 MuraControl for Windows – see page 57.
Using third-party graphics hardware
*
with Mura IPX Series capture cards
1 Install your Matrox cards – see page 24.
2 Connect your cards –
 Third-party hardware. For more information, see the documentation for your
graphics hardware.
* For more information on supported third-party graphics cards, see the release notes. For information on how to configure your
system, see “Matrox System Builder’s Guide.”