Matrox C Series - Validating the Network Discovery of Your Mura IPX Series Cards; Multiple Subnet Support

50 Matrox Display Wall – User Guide
Validating the network discovery of your
Mura IPX Series cards
Matrox Mura IPX Series cards are initially assigned their IP addresses through DHCP (Dynamic Host
Control Protocol). After connecting your devices, we recommend verifying that all your devices are
discovered by the network.
Under the
Network section in the Windows File Explorer , make sure the Mura IPX Series cards and
IP source devices connected to the network are listed.
If prompted to enable network discovery and file sharing on your network when validating network
discovery, enable these two features by clicking the prompt at the top of your Windows Explorer
window. These two features must be enabled for Windows to detect the Mura IPX Series cards on your
subnet.
Multiple subnet support
Mura IPX Series in the same subnet can be detected through the UPnP (Universal Plug and Play)
protocol. If you have cards in different subnets of your network, you need to validate network
discovery in each subnet separately.