32 Matrox Display Wall – User Guide
Connecting your Mura IPX Series display
card
This section describes how to connect your Mura IPX Series 4K IP Decode and Display card.
MURAIPXO-D4LF • MURAIPXO-D4LHF
Connection overview
Desciption of supported connections
Note
: To make sure your cables are securely attached to your Matrox cards, use a cable retention
bracket. To purchase a cable retention bracket, contact your Matrox representative. For more
information, see “Appendix C – Matrox secure cable solution”, page 87.
Note
: Audio output is supported only on the DisplayPort connector labeled
1
of your Mura IPX
Series display card.
Device connector Description
DisplayPort If your monitor has a DisplayPort connector, attach your mini
DisplayPort to DisplayPort cable to your Matrox card. Connect the
other end of the cable to your monitor.
DVI If your monitor has a DVI connector, use a mini DisplayPort to DVI
adapter (active
*
) to connect to the mini DisplayPort connector on your
Matrox card. Connect your monitor to the DVI connector on your
adapter.
Mini DisplayPort to
DisplayPort cables
Network cable
(RJ-45)
To Next Page
Loading...
