Troubleshooting Comet Executive Gas
6-10
WARNING
Only trained personnel with experience
in gas, electrical or mechanical repair
should troubleshoot and repair the unit.
Troubleshooting
WARNING
Read the REPAIR chapter and make
sure that the power is disconnected
before doing any repairs.
ISSUE POSSIBLE CAUSE SOLUTION
Flatwork Scorched or Discol-
ored
1. If flatwork rinses clean with
a small amount of soap, a
chemical residue is left over
from the wash cycle.
• Adjust the settings of the washer.
2. If flatwork does not rinse
clean, the temperature is
set too high, the ironing
speed is too slow, and/or
moisture retention from the
washer/extractor is incor-
rect.
• Refer to Operating Techniques on
page 3-12.
3. If rust-colored spots occur
on the flatwork, there is a
condensed wax buildup
under the canopy and/or
the feed table.
• Check and clean any condensed wax
buildup under the canopy and the feed
table.
Flatwork Does Not Dry Cor-
rectly
1. Processing standards are
not being followed.
• To review the directions for setting up
these standards, refer to Processing
Standards on page 3-15.
2. Flatwork left in a hamper
for a long time will have an
uneven moisture content.
• Increase heat or decrease ironing speed
SLIGHTLY for linen that feels more
damp.
3. Flatwork run through
washer/extractor with cold
water will have less mois-
ture extracted.
• Increase nal flatwork temperature
from extractor. Refer to Condition-
ing Flatwork Before Ironing on page
3-12.
4. Extractor is not removing
enough moisture.
• To review the extraction process, refer to
Conditioning Flatwork Before Ironing
on page 3-12.
5. TEMPERATURE control is
not working properly.
• Replace the TEMPERATURE control.
Refer to Temperature Control or High
Temperature Limit Control Replace-
ment on page 7-34.
To Next Page
Loading...