Comet Executive Gas Installation
2-1
Chapter 2
INSTALLATION
This chapter contains installation instructions for the Comet Executive™ Gas and includes the
following sections:
2.1 Site and Utility Requirements
2.2 Installation Procedures
2.3 Pre-Operational Checkout
The unit was tested under load conditions at the factory and inspected to ensure proper operation. It
was shipped in working condition and is completely assembled except for the receiving shelves and the
exhaust blower assembly. Sucient strapping, blocking, and bracing were provided to give reasonable
assurance that no shipping damage would occur.
NOTE: If the unit is received in damaged condition, notify the carrier at once.
Chicago Dryer Company’s responsibility for shipping damage, other than the standard warranty,
ceases upon delivery to the carrier. For more information on the warranty, see the full page warranty
statement at the front of this manual.
To Next Page
Loading...