Comet Executive Gas Installation
2-25
Checkout Completion
If any of the checkout steps are unsuccessful,
refer to TROUBLESHOOTING for additional
information.
If the problem cannot be determined/solved,
contact your local CHICAGO
®
distributor or
Chicago Dryer Company’s factory service
department.
Cleaning the Unit
During shipment and installation of the unit,
dirt or other contaminants may accumulate that
will soil or mark processed atwork.
Clean the unit by running old pieces of
atwork using the entire width of the unit.
For information on processing atwork, refer
to Flatwork Handling on page 3-9.
NOTE: Units with chrome
ironing cylinders do not require
an initial waxing.
After completing all checkout procedures,
the ironing cylinder can be waxed. For more
information, refer to Waxing on page 3-7.
To Next Page
Loading...