Maxi Comet Executive Exec-66-G - Disconnect Switch and Fuses; Step-Down Transformer

Comet Executive Gas Operating Principles
5-3
Disconnect Switch and Fuses
The unit comes equipped with a disconnect
switch (DDS). This switch (Figure 5-1, A) is in
the electrical panel inside the right endframe.
Included as a part of the disconnect switch are
a set of fuses (Figure 5-1, B), which will isolate
the unit from the mains if necessary. See the
SCHEMATIC PARTS LIST for the rating of
these fuses, which is dependent on line voltage.
NOTE: The power supplied to the
unit must match the requirements
listed on the nameplate.
Additional fuses protect the drive motor
inverter (Figure 5-1, C) and the transformer (D).
Step-Down Transformer
If the ironer is installed in a property with line
voltage higher than 240 VAC, transformer T2 is
provided (Figure 5-2) on the inner wall of the
right endframe. This steps down the voltage to
the 240 VAC.
Figure 5-1: The disconnect switch and fuse set in
the electrical panel inside the right
endframe.
D
A
B
C
T2
Figure 5-2: T2 for high voltage units.
TOC
INDEX