Repair Comet Executive Gas
7-4
7.3 Feed Section
Flatwork is directed into the unit through the
feed section, which consists of the following
components (Figure 7-1):
• Feed Table (A)
• Feed Ribbon Drive Roll (B)
• Feed Ribbons (C)
• Guide Tapes (D)
Various of these components require periodic
adjustment, replacement, or occasional repair.
These procedures include:
• Feed Ribbon Tension Adjustment
• Feed Ribbon Replacement
• Feed Ribbon Drive Roll Friction
Material Replacement
• Guide Tape Replacement
• Feed Table Alignment and Positioning
A
B
C
D
Figure 7-1: Feed section components.
To Next Page