Maxi Comet Executive Exec-66-G - Page 239

Comet Executive Gas Index
I-1
INDEX
A
Alignment and Positioning, Feed Table 7-13
Annual PM (2000 Hours) 4-17
Check and Clean Pilot Assembly 4-18
B
Bearings, Greasing
Monthly 4-14
Weekly 4-8
Broken or Missing Ribbon Replacement
Feed 7-7
Return 7-39
Burner System 7-29. See also Heating System
Burner Removal/Replacement 7-29
Burner Tip Maintenance 7-32
Components 5-9
Temperature Control
About 5-10
Replacement 7-34
Temperature Sensor Contact Shoes
About 5-10
Check and Clean 4-4
Replacement 7-33
High Temperature Limit Control Replacement
7-34
Ignition, Heating System Troubleshooting 6-13
Operation, Heating System Troubleshooting 6-14
Operation Stage, Sequence of Operation 5-12
Pilot Assembly, Check and Clean 4-18
C
Check
Compression Roll Pressure and Padding Condition
4-15
Gas Pressure 4-16
Guide Tapes 4-4
Ironing Cylinder 4-7
Mechanical and Electrical Connections 4-16
Ribbon Condition and Tension 4-12
Safety Equipment 4-5
Setscrews 4-13
Check and Clean
Inverter 4-7
Motors 4-11
Pilot Assembly 4-18
Sail Switch and Exhaust Blower Wheel 4-11
Temperature Sensor Contact Shoes 4-4
Clean Behind Service Panels 4-6
Clearing a Jam Safely 3-10
Compression Roll 7-16
Check Pressure and Padding Condition 4-15
Cover Replacement 7-19
Pressure
Adjustment 7-18
Check 7-17
Unit Settings 3-14
Conditioning Flatwork Before Ironing 3-12
Final Rinse 3-13
Moisture Retention 3-13
Timing Between Washing and Ironing 3-13
Wash Load 3-12
Control Function Check 2-19
Controls, Operating. See Operating Controls
Cover Replacement
Compression Roll 7-19
Feed Ribbon Drive Roll Friction Material 7-8
Return Ribbon Drive Roll Friction Material 7-40
D
Daily Operating Procedures. See Standard Operat-
ing Procedures
Daily Operation Safety 1-3
Daily PM (8 Hours) 4-3
Check
Guide Tapes 4-4
Safety Equipment 4-5
Check and Clean Temperature Sensor Contact
Shoes 4-4
General Cleanliness 4-3
Watch and Listen for Anything Abnormal 4-3
Wax Ironing Cylinder 4-5
Disconnect Switch and Fuses 5-3
Drive Chain
Oil 4-14
Tension Adjustment 7-23
Drive Roll Friction Material Replacement
Feed Ribbon 7-8
Return Ribbon 7-40
Drive System 5-5
Ductwork 2-5
TOC
INDEX