Page14Alterations reserved Version 05/2008
Operating Manual B21-C - en
1.6 Equipment
1.6.1 Buckle folding machine
The buckle folding machine works exclusively in accordance with the principle of buckle folding.
The MBO buckle folding machine B21 with pile feeder has been developed to process sheets in
the sizes of 6 x 6 inch up to 21 x 33 inch. The production speed can be regulated between 400
and 8000 inch/min. However, this result depends on the type and size of sheet and type of fold.
The basic machine consists of a folding unit one with pile feeder as well as the well-proven MBO
register table.
1.6.2 Folding unit one
The folding unit one is equipped with four (optional six) stainless-steel buckle plates, sheet stop
fine adjustment and integrated swing deflectors. Moreover, it is also equipped with the well-proven
MBO spiral foldrollers, which may be adjusted through the quick-setting elements located on top
of the machine, combined with the low-noise belt drive system and solid, quickly removeable
slitter shafts through plug bearings.
1.6.3 Folding unit two
The folding unit two is a mobile buckle folding unit with own drive, register table, a maximum
working width of 21 inch as well as four buckle plates as descriped above.
1.6.4 Knife folding unit „X“
The knife folding unit “X”, which is equipped with belt drive system, maximum working width of
21inch, and electronical knife control is useable as a folding unit two or three.
The knife folding unit “X” has an own drive and self-control.
1.6.5 Hook on stream delivery
The hook-on stream delivery SE500/3 is available in the configurations B21/4 ; B21/6 ; B21/44 ;
B21/64; B21/66 as standard. The mobile delivery A56 is optional. Machines with a unit ”X”
configuration, 4X ; 6X ; 44X; 64 or 66X, must choose the optional A56 ,because SE500/3 can
not be suspended at the ”X” unit.
The following description from the feeder to the machine should enable the operator to achieve a
general understanding of the machine.
To Next Page
Loading...
