Page80Alterations reserved Version 05/2008
Operating Manual B21-C - en
Light (porous) paper = plastic or less balls
Heavy paper = steel or more balls
A screw with a spring is located on top of this ball holder 12. If you turn in this screw it will avoid
the ball jamping during fast production.
You may place a stop switch to the exits of the folding units which will turn off the machine in
case of jam-ups (optional).
The foldrollers, sheet deflectors, slitter shafts and noise damping device are used and adjusted as
described previously.
6.3 Electrical connection
The electrical connection occurs through
the cable with power plug 1 and control
plug 2 at control cabinet of the previous
folding unit.
A dummy plug 3 should be plugged into
the control socket 4 for the control cable,
if no subsequent folding unit or delivery is
used.
6.4 Control panel
5 Red mushroom button for EMERGENCY-STOP
6 Red button for machine STOP
7 Black button for machine START
8 White button for SHEET INFEED
9 White button for SHEET INFEED one Sheet
10 Potentiometer for electronical speed regulation
6.5 Foldrollers and slitter shafts at subsequent folding units
Settings of foldrollers and slitter shafts should be carried out as described under item B7.
You will find the MBO setting instructions of the most commonly folds under item D1 - D3.
Danger of electric tension.
Negligence can cause, heavy injuries or death.
Report damaged electrical connections to respnsible supervisor.
'$1*(5
3
4
5
6 7 8 9
12
1
To Next Page
Loading...
