M
AVTM246004 BITE 2/2P Rev 4 July 2011
134
• To save the new settings and initialize the serial port, click
Save Settings.
• To leave the parameters as they were when you accessed
the tab, click Restore Settings.
NOTE: Even if you have made changes and have clicked Save
Settings, the settings will be restored to those in effect when you
first accessed the tab.
If the Run in Test Mode check box is checked, the serial port is
not used and the remote device cannot be accessed.
Run in Test Mode
The Test mode does not support all commands. The commands
currently supported are.
SET.PASSWORD
SET.SETTINGS
SET.WAVEFORM (NO FILES ARE ACTUALLY TRANSFERRED)
LOGIN
LOGOUT
GET.SETTINGS
GET.PRINTERLIST
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
