Megger BITE 2 - Powering down and Disconnecting the BITE 2;2 P

STANDARD TEST PROCEDURE
AVTM246004 BITE 2/2P Rev 4 July 2011
45
(EXPORT DATA)
Y TRANSMIT DATA
N (Y/N?) MENU
1. Press for TRANSMIT. The screen will display the
following screen.
EBITE/PC
PRINTER MENU
2. Press for PRINTER then SELECT. You will be
prompted to enter the test number. During printing the
following screen will appear:
ALLTESTS
SELECT
3. Press until the active test number is displayed. In this
example, six is the active test.
TEST 001 OF 006
O = CANCEL ACCEPT
4. Reconnect the potential probe to resume testing. The
measurement screen is displayed again.
Powering Down and Disconnecting the BITE 2/2P
Before you power down and disconnect the BITE 2/2P
transmitter, first power down and disconnect the receiver.
Then power down and disconnect the transmitter. Carefully
follow these steps:
1. To power down the receiver, press the key on the
receiver until the LCD displays the following:
POWER DOWN
EXPORT DATA MENU
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com