TRANSFERRING, PRINTING, AND DELETING TEST RESULTS
AVTM246004 BITE 2/2P Rev 4 July 2011
57
Figure 6-1: Exporting data to a PC
If the RS-232 communication
cable is not connected, the
receiver displays a message
instructing you to connect it.
4. Connect the plug of the RS-232 communication
cable/printer (Cat. No. 35340) to the 7-pin connector
on the receiver. Then insert the pin end of the
communication cable into the com port on the PC.
5. Press
on the receiver to select EXPORT DATA.
The receiver prompts you to select EBITE/PC or
printer.
EBITE/PC
PRINTER MENU
6. Press
on the receiver to select PC.
A screen on the receiver tells you to wait as the test results
are transferred.
When the transfer is complete, the receiver prompts you to
choose POWER DOWN or EXPORT DATA.
POWER DOWN
EXPORT DATA MENU
7. Disconnect the RS-232 communication cable from both
the receiver and the PC.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
