M
AVTM246004 BITE 2/2P Rev 4 July 2011
89
10
OPTIONAL EQUIPMENT
Available Options
To accommodate testing requirements of various battery
installation configurations, Megger offers the following
optional equipment for the BITE 2 and BITE 2P.
Current sensor—Miniature clamp-on CT with 0.5-in. (12-
mm) opening for use in small cabinets. This current sensor
has shrouded banana-jack connections and includes a 2.5 ft
(0.75 m) lead.
Current sensor—RopeCT
TM
: In some battery installations,
the buswork is too big for the standard 2 in. (50 mm) CT to
close. There are two lengths, 24 in. (60 cm) and 36 in. (90
cm) to make 8 in. (20 cm) and 12 in. (30 cm) diameter circles.
Because they are flexible, they can adapt to almost any
buswork configuration.
Bar code wand—for use with the receiver’s 7-pin connection
as a means of electronically scanning cell, location, and
operator identification. This option includes a wand and
prompt sheets with alphanumeric characters for scanning.
Windows
®
-based software for producing bar code labels using
a personal computer and printer is also available as a
separate option.
Extended source leads—30 and 40 ft (9 and 12 m).
Extension cable—20-ft (6 m) for clamp-on current sensor (CT).
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
