M
AVTM246004 BITE 2/2P Rev 4 July 2011
58
8. Turn off the power to the transmitter and receiver.
(See "Powering Down and Disconnecting the BITE 2/2P"
on page 45.
Printing Test Results in the BITE 2P Transmitter Printer
To print test results on the built-in printer of the BITE 2P
transmitter, connect the printer cable to the 7-pin connector on the
receiver and to J3 on the BITE 2P transmitter. Follow the menus
on the receiver to select the tests you wish to print.
Figure 6-2: Printing test results
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
