Megger BITE 2 - Receiver Reset Switch; Figure 3-9: Receiver RESET Switch

M
AVTM246004 BITE 2/2P Rev 4 July 2011
24
Receiver Reset
Switch
The RESET switch (see Figure 3-9), located on the receiver
back panel, is only for Megger authorized calibration and
repair. Activating the RESET switch de-energizes the
receiver. Never use the RESET switch. It will result in
permanent loss of data and loss of calibration.
Figure 3-9: Receiver RESET switch
RESET Switch
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com