M
AVTM246004 BITE 2/2P Rev 4 July 2011
46
2. Press
on the receiver to choose POWER DOWN.
The receiver prompts you to confirm your decision.
Y ARE YOU SURE?
N (Y/N)? MENU
3. Press
on the receiver to enter Y (YES). The receiver
powers down.
4. Disconnect the CT from the battery and the receiver.
You can now power down the transmitter.
5. To power down the BITE 2/2P transmitter, press the
Current ON/OFF switch to disconnect the current
source. Then press the transmitter power switch to the
O (OFF) position.
F
WARNING
Do not remove the BITE 2/2P transmitter current source
leads from the battery until the BITE 2/2P transmitter is
powered down. Always disconnect the current source
leads from the battery before removing them from the J2
connector on the transmitter.
6. Remove the current source leads from the battery.
7. Remove the current source leads from the J2 connector
on the transmitter.
Remember to recharge the
receiver battery. Refer to
"Charging the Receiver" on page
74 for detailed procedures.
8. Unplug the power cable and then disconnect it from the
J1 receptacle on the transmitter.
G
CAUTION
Do not leave the BITE 2/2P connected to the battery when
not in use.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
