HARDWARE MANUAL Document reference MAMPS-HW/E
VM600 machinery protection system (MPS) Edition 18 - March 2022
x
Structure of the manual
This section gives an overview of the structure of the document and the information contained
within it. Some information has been deliberately repeated in different sections of the
document to minimise cross-referencing and to facilitate understanding through reiteration.
The chapters are presented in a logical order. You should read those that are most relevant
to you and then keep the document at hand for future reference.
The structure of the document is as follows:
Part I: Functional description of VM600 MPS system
Safety Contains important information for your personal safety and the correct use of the
equipment.
THIS SECTION SHOULD BE READ BEFORE ATTEMPTING TO INSTALL OR USE THE
EQUIPMENT.
Chapter 1
Introduction – Familiarises the user with the function and features of the MPS.
Chapter 2
Overview of VM600 MPS hardware – Provides information on the physical aspects of the
various cards and other components making up the system. Describes the elements on
the panels of the cards and system components.
Chapter 3
General system description – Describes the MPS from a global, rack-level point of view.
Introduces the MPC4 / IOC4T and AMC8 / IOC8T card pairs. Describes the rack
backplane and its buses.
Chapter 4
MPC4 / IOC4T card pair – Contains a block diagram of this card pair and information on
the signal processing performed by it. Provides details on inputs and outputs, rectification
techniques, alarm monitoring possibilities (levels, delay time, hysteresis, logical
combinations), the OK System and the operation of the LEDs on the panel of the MPC4.
Chapter 5
AMC8 / IOC8T card pair – Contains a block diagram of this card pair and information on
the signal processing performed by it. Provides details on inputs and outputs, processing
functions, alarm monitoring possibilities (levels, delay time, hysteresis, logical
combinations), the OK System and the operation of the LEDs on the panel of the AMC8.
Chapter 6
CPUM / IOCN card pair – Provides a brief overview of the function of this card pair and
contains a block diagram of each card.
Chapter 7
Processing modes and applications – Describes the operation of the MPS in all its
operating configurations (broad-band vibration, shaft relative vibration, eccentricity,
dynamic pressure and so on). Processing steps are shown in block diagrams and
additional background information on the measurement type is provided.
To Next Page
Loading...
Need help?
General