SECTION - 8 REMOTE CONTROLS
90-899883183 DECEMBER 2007 Page 5 / 10
b. On right‑hand rotation drive units, place the drive unit into gear by pushing in on the drive
unit shift cable while simultaneously rotating the propeller shaft counter‑clockwise until
the shaft stops. Maintain a light pressure on the drive unit shift cable to hold it at the end
of its travel. This removes all slack from the cable.
7817
c. On left‑hand rotation drive units, place the drive unit into gear by pulling out on the drive
unit shift cable while simultaneously rotating the propeller shaft clockwise until the shaft
stops. Maintain a light pressure on the drive unit shift cable to hold it at the end of its
travel. This removes all slack from the cable.
7870
2. Verify remote control travel for reverse gear.
a. Place the remote control in reverse gear, past detent, and into WOT position.
7869
To Next Page
Loading...
