PREDELIVERY PREPARATION AND STORAGE SECTION - 9
Page 2 / 24 90-899883183 DECEMBER 2007
Lubricant, Sealant, Adhesives
Tube Ref No. Description Where Used Part No.
19
Perfect Seal Aft heat exchanger plug 92-34227 1
34
Special Lubricant 101 Propeller shaft splines 92-802865Q02
87
High Performance Gear Lubricant Gear Lube Monitor 92-858064K01
114
Power Trim and Steering Fluid Power steering pump 92-858074K01
115
Premium Plus 2-cycle TC-W3 Outboard Oil Fuel system 92-858026K01
124
Fuel System Treatment & Stabilizer Fuel system 858071K01
134
Dexron III Automatic Transmission Fluid Power steering pump Obtain Locally
Special Tools
Flushing Device 91‑44357Q 2
Attaches to the water intakes; provides a fresh water
connection when flushing the cooling system or operating the
engine.
Predelivery Preparation
Once the power package installation is complete, the following final steps should be taken to
prepare power package for delivery to the customer. It is the boat manufacturer's responsibility to
perform these procedures, or to make arrangement with the dealer to have these procedures
completed.
Engine Oil
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law.
Use caution not to spill oil, coolant, or other fluids into the environment when using or servicing
your boat. Be aware of the local restrictions governing the disposal or recycling of waste, and
contain and dispose of fluids as required.