DRIVE SYSTEM AND ENGINE INSTALLATION SECTION - 6
Page 42 / 54 90-899883183 DECEMBER 2007
Alpha Sterndrive Installation
1. Remove the trim cylinder support and dust cover from the bell housing studs. Retain the elastic
stop nuts and flat washers.
a
7713
b
Typical
a - Dust cover
b - Trim cylinder support
2. Remove the gear lube monitor cap and fill with lubricant.
a - Gear lube monitor
b - Operating Range line
Tube Ref No. Description Where Used Part No.
87
High Performance Gear
Lubricant
Gear lube monitor 92-858064K01
To Next Page
Loading...
Need help?
General