SECTION - 6 DRIVE SYSTEM AND ENGINE INSTALLATION
90-899883183 DECEMBER 2007 Page 35 / 54
SEAWATER PICKUP
1. Connect the water inlet hose to the water inlet fitting on the transom.
a
b
c
7802
a - Water inlet tube
b - Hose clamp
c - Seawater inlet hose
2. Secure with a hose clamp.
COOLANT RECOVERY SYSTEM
NOTE: This section applies to models with closed cooling only.
1. Select a mounting location for coolant recovery bottle and mounting bracket so that they are:
• Within the limits of the clear plastic tubing.
• Level with or above the heat exchanger fill neck.
• Accessible for observing coolant level and filling.
2. Mount the coolant recovery bottle and mounting bracket in the desired location using two
19 mm (3/4 in.) long screws and flat washers.
3. Route the plastic tubing to the recovery bottle. Ensure that tubing is positioned away from any
moving parts. Cut the plastic tubing as required and connect it to the bottom connection on
the recovery bottle. Secure with the provided tubing clamp.
IMPORTANT: Seal the plastic tubing connections completely to ensure that the coolant recovery
system operates properly.
To Next Page
Loading...
Need help?
General