EasyManuals Logo

Mercury Optimax 115 User Manual

Mercury Optimax 115
522 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #135 background imageLoading...
Page #135 background image
WIRING DIAGRAMS
Page 2D-20 90-855347R1 JANUARY 1999
ENGINE OVERHEAT
a
a
The system is activated when the engine temperature is too hot.
The TEMP light (a) will come on and the warning horn begins sounding. The warning sys-
tem will automatically limit the engine speed to 3000 RPM. After the engine has cooled,
shift the outboard into neutral to reset the overheat circuit.
IGNITION COIL, SENSOR, OR INJECTOR NOT FUNCTIONING
a
a
The system is activated if an ignition coil, sensor or injector is not functioning correctly.
The CHECK ENGINE light (a) will turn on.
THROTTLE SENSOR NOT FUNCTIONING
a
a
The system is activated if the throttle sensors are not functioning correctly.
The CHECK ENGINE light (a) will turn on and the warning horn will begin sounding.
WATER SEPARATING FUEL FILTER IS FULL OF WATER
a
The water level detection warning is activated when water in the water separating fuel fil-
ter reaches the full level. The water can be removed from the filter.
The WATER DETECTION light (a) will come on and the warning horn will begin sounding
a series of four beeps. If you continue to operate the outboard, the light will stay on and
the horn will sound every two minutes.

Table of Contents

Other manuals for Mercury Optimax 115

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury Optimax 115 and is the answer not in the manual?

Mercury Optimax 115 Specifications

General IconGeneral
Fuel Induction System2-stage Direct Fuel Injection (DFI)
Alternator Amp60 amp / 756 watt
SteeringRemote
Cylinders3
StartingElectric
Displacement1.5 L
Bore x Stroke89 x 76 mm
Shaft Length20" (508 mm)
Horsepower115 HP

Related product manuals