6 - ORDINARY MAINTENANCE
6 - 8
NUTS AND BOLTS FASTENING THE AXLES THE FRAME
FRONT BRIDGE (A)
Torque (13,5 Kgm) the crossways tilt
corrector securing screws of the jacks
(8 screws for each of the two jacks)
Torque (70 Kgm) the horizontal long-
life tie-rods clamping nuts (2 nuts for
each of the four tie-rods)
REAR AXLE (P)
Tighten the 8 fixing screws "V2" of the
rear axle to the chassis, with a torque
of 45Kgm.
To better understand the position of the "V2" screws which fasten the front (A) and rear (P) axles to the frame, refer to the
drawing below:
• SCHEDULED MAINTENANCE AFTER THE FIRST 100 HOURS
CARDAN JOINTS
Grease the front (F) and rear (R) universal joints at the indicated points:
A – grooved profiles
B - crossings
HYDROSTATIC TRANSMISSION OIL FILTER
For information on the hydrostatic transmission oil filter replacement, refer to the specific paragraph "EVERY 500 HOURS".
HYDRAULIC OIL RETURN FILTER
For information on the hydraulic oil filter replacement, refer to the specific paragraph "EVERY 500 HOURS".
To Next Page
Loading...