6 - ORDINARY MAINTENANCE
6 - 23
• DIESEL OIL FILTER
(only for models with KUBOTA engine)
Check the clogging of the diesel oil filter "A" in the following way:
- stop the machine engine.
- inspect the diesel oil filter "A"
If the diesel filter is excessively dirty, clean it as follows:
- remove the retaining clamps "B" and disconnect the diesel oil filter from
pipelines
- directing a jet of compressed air in the opposite direction to the flow of fuel to
remove any sediments present in the filter
- inspect the inside of the filter and verify that the mesh is in good condition and
free from obstructions; otherwise replace it with a part from the Merlo Technical
Assistance service
- replacing the filter, connecting the pipelines and securing the retainer clamps
"B"
WARNING! The diesel oil filter has an arrow on the plastic casing which indicates the flow direction of the fuel;
replacing the filter on the engine, paying particular care that it is in the correct direction. Otherwise it will lose its
protective efficacy.
• CHAIN TRANSFER UNIT OIL
Check the oil level inside the chain
transfer unit:
- the chain transfer unit is located
inside the engine compartment;
- remove the cap "A"
- check that oil reaches the lower
edge of the hole
- if necessary, top up with specific oil
(see paragraph "FUELS &
LUBRICANTS")
- put back the cap "A"
To Next Page
Loading...