6 - ORDINARY MAINTENANCE
6 - 27
• HYDRAULIC OIL
To correctly change the hydraulic oil, do as follows:
- Fully retract and lower the telescopic boom
- Stop the machine diesel engine
- Remove filling cap "B"
- Extract and clean the magnets
- Remove discharge cap "C" and empty the hydraulic oil into an appropriate container
- Close the discharge cap "C"
- Pour some new hydraulic oil through the filler cap "B"; use only the hydraulic oil indicated in the "OIL TABLE" in chapter
"STICKERS WITH CONTROL DESCRIPTIONS - LEAFLETS IN THE CAB"
- Check that the level of the hydraulic oil poured into the system is about 5 mm from the upper edge of the indicator glass
"A". Close the filling cap "B".
The total capacity of the system is 105 litres (140 litres for P40.17 – P40.17PLUS – P40.17EE)
• GEAR BOX OIL
To correctly change the gearbox oil,
do as follows:
- Stop the machine diesel engine
- open covering housing "2" as
described in paragraph
"COVERS" in section
"ORDINARY MAINTENANCE"
- remove the filler cap "A"
- Remove discharge cap "B" and
collect the gearbox oil in an
appropriate container
- close the discharge cap "B"
- Pour some new gearbox oil through filler cap "A" until it starts flowing out; use only the gearbox oil indicated in the "OIL
TABLE" in chapter "STICKERS WITH CONTROL DESCRIPTIONS - LEAFLETS IN THE CAB"
- Close the filler cap "A".
SYSTEM CAPACITY
The total capacity of the system is 3 litres.
• BRAKE FLUID
The replacement of brake fluid and bleeding of the system must be performed by qualified personnel.
The overall capacity of the system is 300 ml
To Next Page
Loading...