Metronics Quadra-Chek 200 - Page 48

Chapter 2 Quick-Start Demonstration
2-22
Step 6
Enter the nominal diameter.
Step 7
Enter the tol zone of the circle as shown.
NOTENOTE
NOTENOTE
NOTE
The The
The The
The
tol zone (tolerance zone)tol zone (tolerance zone)
tol zone (tolerance zone)tol zone (tolerance zone)
tol zone (tolerance zone)
of the circle is the radius within of the circle is the radius within
of the circle is the radius within of the circle is the radius within
of the circle is the radius within
which the center point of the circle must be. If the center pointwhich the center point of the circle must be. If the center point
which the center point of the circle must be. If the center pointwhich the center point of the circle must be. If the center point
which the center point of the circle must be. If the center point
lies outside this radius the tolerance will fail.lies outside this radius the tolerance will fail.
lies outside this radius the tolerance will fail.lies outside this radius the tolerance will fail.
lies outside this radius the tolerance will fail.